The RT16-10 Router is a ONE-IN/SIXTEEN-OUT switcher which directs an infrared control signal to any one, multiples or all 16 output ports. Now you can control large groups of TV monitors (or any other A/V product) from control locations using Xantech IR Receivers or SmartPads. Up to 16 devices may be addressed with one RT16-10. In addition, the "I" and "G" output ports can drive LED indicators placed at each controlled device location so that you can see which devices are being addressed at any given time. An ID CODE SWITCH, along with the appropriate RC68+ commands, permits specific routing modes as follows: Single Routing - Allows any individually selected port to be driven with an IR control signal separate from the others. Multiple Routing - IR control signals can be routed to any desired combination of ports (1 through 16) for simultaneous operation. This is useful if you wish to address smaller groups of units for special purposes. The chosen IR routes remain on, allowing you to control just the selected devices, until the Group Off command from the RC68+ is sent. You may make up sequences (macros) in a learning device (such as the Xantech SmartPads) for each routing combination you desire for rapid access to the controlled groups. Group On - In this mode all 16 IR routes are chosen simultaneously with the Group On command. This is useful if you wish to quickly address all IR outputs at the same time. Group Off - Turns the IR signal off at all IR outputs

•The RT16-10 respond to Xantech RC68+ Hand Held Programmer codes.
•CODE GROUP NUMBERS - The RT16-10 is capable of being set to 55 different code groups. The code groups are identified by the numbers and letters that are on the face of e

Customer Reviews:

Be the first to write a review !